Toshiba e-studio 6560c - IH Board; Fuser Unit Jam Releasing LED

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 204
4.9.22 IH board (IH)
4.9.23 Fuser unit jam releasing LED (LED)
(1) Open the SYS board case.
 P. 9-2"9.1.3 SYS board case"
(2) Take off the IH board cover and the harness
of the IH coil.
 P. 4-197"4.9.16 IH coil"
(3) Disconnect 3 connectors from the IH board
[1].
(4) Remove 5 screws and take off the IH board
[1].
Fig. 4-591
(1) Take off the right corner cover.
 P. 4-8"4.1.22 Right corner cover"
(2) Open the front cover and pull out the bridge
unit.
(3) Remove 2 screws and then take off the inner
cover.
Fig. 4-592
(4) Remove 1 screw and disconnect the
connector to take off the LED bracket.
(5) Remove 1 screw and then take off the fuser
unit jam releasing LED [1].
Fig. 4-593
[
1
]
[
1
]