6
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
SETTING ADJUSTMENT
6 - 43
6.2.14 Text/Photo reproduction level adjustment
Text/Photo reproduction level at the Full color mode and Auto color mode can be adjusted.
Text/Photo reproduction level adjustment can be switched to “Photo oriented 1”, “Photo oriented 2”,
“Text oriented 1” or “Text oriented 2” in the following codes.
<Adjustment Mode (05)>
Notes:
• The text reproduction level is lower when the mode is switched from the default value to the
Photo oriented 1 or Photo oriented 2. (The text reproduction level in Photo oriented 2 is lower
than that in Photo oriented 1.)
• When you change the setting from the default value to “Text oriented 1” or “Text oriented 2”,
noise occurs in a printed photo with a few lines. (More noise occurs in “Text oriented 2” than
“Text oriented 1”.)
• The codes for the user custom setting are enabled only when the base original mode of the
user custom mode is Text/Photo.
<Procedure>
The procedure is the same as that of P. 6-33"6.2.2 Density adjustment".
Mode Mode
Item to be adjusted Contents
Text/Photo
Custom
mode
(Text/Photo
base)
7840 7841 Text/Photo
reproduction level
adjustment
0: Default
1: Photo oriented 2 (The printed image
reproduction level higher than that of the Photo
oriented 1)
2: Photo oriented 1 (The printed image
reproduction level higher than that of the Default)
3: Equivalent to the Default
4: Text oriented 1 (The text reproduction level
higher than that of the Default)
5: Text oriented 2 (The text reproduction level
higher than that of the Text oriented 1)
To Next Page
Loading...
