Toshiba e-studio 6560c - Drum Thermistor (K;Y); Developer Unit

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 110
4.6.23 Drum thermistor (K/Y) (THM1/THM2)
The drum thermistor is installed only on the Y and K drums.
4.6.24 Developer unit
(1) Take off the solenoid holder.
 P. 4-107"4.6.21 V0 sensor shutter
solenoid (K) (SOL) (e-STUDIO6550C/6570C
only)"
(2) Release 1 lock and then take off the drum
thermistor.
Fig. 4-321
(1) Take off the front cover.
 P. 4-1"4.1.2 Front cover"
(2) Take off the drum cleaner unit.
 P. 4-95"4.6.2 Drum cleaner unit"
(3) Take off the sub-hopper.
 P. 4-100"4.6.11 Sub-hopper"
(4) Remove a connector holder.
Fig. 4-322
(5) Remove 1 screw and the developer unit
locking.
Notes:
Be sure not to drop screws into the toner
inlet.
Fig. 4-323
Drum thermistor
Connector holder
Developer unit locking