e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 192
4.9.13 Pressure roller center thermistor (THM3) / Pressure roller side
thermistor (THM4) / Pressure roller edge thermistor (THM5)
(1) Take off the pressure roller cover.
P. 4-173"4.9.2 Pressure roller cover"
(2) Take off the entrance guide cover.
P. 4-175"4.9.5 Entrance guide cover"
(3) Take off the rear plate.
P. 4-176"4.9.7 Separation plate"
(4) Release the harnesses of the pressure roller
thermistors (center, side and edge) from the
hook of the harness guide.
Notes:
When installing, be sure to fix the harness
with the hooks of the harness guide.
Fig. 4-555
(5) Remove 1 screw and take off the terminal
plate.
(6) Release the harness from 2 clamps.
Notes:
• When installing, be sure to fix the harness
securely with 3 clamps
• The pressure roller heater lamp has 3
harnesses for MJC and MJD destinations,
and 2 harnesses for the others.
Fig. 4-556
(7) Remove 2 screws and take off the harness
guide [1].
Notes:
When installing, align 2 dowels and 2 hooks
of the harness guide [1] with the frame.
Fig. 4-557
To Next Page
Loading...
