9
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
REPLACEMENT OF PC BOARDS/HDD
9 - 41
[P] Set EFI Printer Board
If the EFI Printer Board (GA-1310) is installed, perform the following procedure.
(1) Turn the power OFF.
(2) Start the setting mode (08).
(3) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [ENTER] button without entering anything.)
(4) Initialize the EFI Printer Board (08-9951).
(5) Turn the power OFF.
To Next Page
Loading...
