Toshiba e-studio 6560c - Feed Roller; Pickup Roller

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 56
4.5.15 Feed roller
4.5.16 Pickup roller
(3) Pull out the drawer.
(4) Disconnect 1 connector and remove 2
screws. Then take off the drawer feeding
unit.
Notes:
When taking off the drawer feeding unit of
the 1st drawer, perform position adjustment
for the media sensor after the unit was
reinstalled.
 P. 6-83"6.7.1 Adjustment of the media
sensor position"
Fig. 4-159
(1) Take off the drawer feeding unit.
 P. 4-55"4.5.14 Drawer feeding unit"
(2) Remove 1 clip. Press down the lever and
take off the feed roller.
Fig. 4-160
(1) Take off the drawer feeding unit.
 P. 4-55"4.5.14 Drawer feeding unit"
(2) Remove 1 clip and take off the pickup roller.
Fig. 4-161
Drawer feeding unit
Feed roller
Lever
Pickup roller