e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
PREVENTIVE MAINTENANCE (PM)
7 - 4
7.3 General Descriptions for PM Procedure
(1) Preparation
• Ask the user about the current conditions of the equipment and note them down.
• Before starting maintenance, make some sample copies and store them.
• See the replacement record and check the parts to be replaced in the PM support mode (6S-
2) or list printing mode (9S-103).
6S : [6] + [START] + [POWER] ON
9S-103 : [9] + [START] + [POWER] ON [103] [START]
Fig. 7-1
• Turn OFF the power and make sure to unplug the equipment.
(2) Perform a preventive maintenance using the following checklist and illustrations.
(3) Plug in the equipment after the maintenance has been finished. Then turn ON the power and
make some copies to confirm that the equipment is working properly.
PM SUPPORT CODE LIST S/N : CLE000007 FIN S/N : FIN S/N-xxxxxxxx TOTAL : 2146
2011-02-09 13:16 TOSHIBA e-STUDIO6550C DF TOTAL : 1213
UNIT OUTPUT PAGES PM OUTPUT PAGES DRIVE COUNTS PM DRIVE COUNTS
DEVELOP COUNTS DEVELOP COUNTS
DRUM(K)
DRUM BLADE(K) 9020 275000 24911 285000
GRID(K) 9020 275000 24911 285000
MAIN CHARGER NEEDLE(K) 9020 275000 24911 285000
CHARGER CLEANING PAD(K) 9020 275000 24911 285000
DRUM(Y) 6208 275000 21136 285000
DRUM BLADE(Y) 6208 275000 21136 285000
GRID(Y) 6208 275000 21136 285000
MAIN CHARGER NEEDLE(Y) 6208 275000 21136 285000
CHARGER CLEANING PAD(Y) 6208 275000 21136 285000
DRUM(M) 6208 275000 21136 285000
DRUM BLADE(M) 6208 275000 21136 285000
GRID(M) 6208 275000 21136 285000
MAIN CHARGER NEEDLE(M) 6208 275000 21136 285000
CHARGER CLEANING PAD(M) 6208 275000 21136 285000
DRUM(C) 6208 275000 21136 285000
DRUM BLADE(C) 6208 275000 21136 285000
GRID(C) 6208 275000 21136 285000
MAIN CHARGER NEEDLE(C) 6208 275000 21136 285000
CHARGER CLEANING PAD(C) 1077 275000 21136 285000
To Next Page
Loading...
