Toshiba e-studio 6560c - Lower Paper Exit Roller

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 213
4.10.10 Lower paper exit roller
4.10.11 Bridge unit
(1) Take off the bracket of the lower paper exit
roller unit.
 P. 4-209"4.10.6 Lower paper exit sensor
(S63)"
(2) Remove the E-rings and take off the gears.
Fig. 4-617
(3) Take off the lower paper exit roller by
removing the E-ring and the bearing.
Fig. 4-618
(1) Open the front cover and then pull out the
bridge unit.
(2) Remove 4 screws from a rail.
Fig. 4-619
Lower paper exit roller
Bearing
Bearing
Bridge unit