Toshiba e-studio 6560c - Drum Cleaning Blade

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 97
4.6.3 Drum
4.6.4 Drum cleaning blade
(1) Take off the drum cleaner unit
 P. 4-95"4.6.2 Drum cleaner unit"
(2) Take off the main charger unit.
 P. 4-99"4.6.6 Main charger unit"
(3) Take off 2 drum holders.
(4) Take off the drum by lifting it up straight.
Fig. 4-282
Notes:
Do not install the drum in a wrong direction.
Do not touch the drum flange on the rear
side (shown in grey in the figure) because
grease will adhere to your hands.
Fig. 4-283
(1) Take off the main charger unit.
 P. 4-99"4.6.6 Main charger unit"
(2) Take off the drum.
 P. 4-97"4.6.3 Drum"
(3) Remove 2 screws and then take off the drum
cleaning blade.
Notes:
When replacing the drum cleaning blade,
replace the blade side seal too if the
conditions of the blade side seal are as
follows:
• If the flock on the surface layer of blade
side seal has peeled off and the sponge
of the layer below protrudes.
• If not in accordance with P. 4-98"Fig. 4-
286" and P. 4-98"Fig. 4-287" of “4.6.5
Blade side seal”.
Fig. 4-284
Drum
Drum holder
Drum holder
Rear
Front
Drum cleaning blade