Toshiba e-studio 6560c - In the Case of Bypass Feeding

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING ADJUSTMENT
6 - 90
Fig.6-47
<In the case of bypass feeding>
(1) Move the side guides halfway to the center.
(2) Loosen 1 screw.
(3) Move the rear side guide to the front or rear
side.
* The position of the screw is adjustable
within the diameter of the long screw
hole; from - 3 mm to + 3 mm.
(4) Fix the 1 screw.
Notes:
The paper transport position is moved the
same amount and direction as the side
guide.
Fig.6-48
3 mm
2 mm
1 mm
Moved
by
Transport position moved to the
rear side
Transport position moved to the
front side
Default