Toshiba e-studio 6560c - Duplexing Unit Path Entrance Sensor

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 251
4.10.49 Duplexing unit path entrance sensor (S66)
(5) Remove the film and then take off the fuser
transport sensor from its bracket.
Fig. 4-731
(1) Pull out the duplexing unit.
(2) Remove 5 screws and then take off the
duplexing unit left side cover from the 2
hooks.
Fig. 4-732
(3) Remove 1 screw and then take off a sensor
bracket.
(4) Disconnect the connector from the duplexing
unit path entrance sensor.
Fig. 4-733
Fuser transport sensor
Bridge unit left side cover
Sensor bracket