Toshiba e-studio 6560c - Lower Exit Section Cooling Fan-3; Exit Motor

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 207
4.10.3 Lower exit section cooling fan-3(F36)
4.10.4 Exit motor (M2)
(1) Take off the left top cover.
 P. 4-4"4.1.10 Left top cover"
(2) Disconnect a connector by releasing the
harness from the clamp.
(3) Take off the lower exit section cooling fan-3
by removing 2 screws.
Fig. 4-599
(1) Take off the receiving tray.
 P. 4-3"4.1.8 Receiving tray"
(2) Take off the left top cover.
 P. 4-4"4.1.10 Left top cover"
(3) Release the harness from 2 clamps [1].
(4) Disconnect all the connectors of the DRV
board [2].
(5) Remove 4 screws to take off the DRV board
[2].
Fig. 4-600
(6) Remove 2 screws and disconnect a
connector. Then take off the motor bracket.
Fig. 4-601
Lower exit section cooling fan-3
[
1
]
[
2
]
Exit motor