Toshiba e-studio 6560c - Drawer Paper Size Detection Sensor-1;2; Registration Motor

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 69
4.5.34 Drawer paper size detection sensor-1/2 (S79/S80/S87/S88/S95/
S96/S103/S104)
4.5.35 Registration motor (M39)
(1) Take off all the drawers.
 P. 4-68"4.5.33 Drawer"
(2) Disconnect 1 connector and release 2 hooks.
Then take off each sensor.
Fig. 4-200
(1) Open the SYS board case.
 P. 9-2"9.1.3 SYS board case"
(2) Disconnect 1 connector and remove 3
screws. Then take off the registration motor
with the bracket.
Notes:
When installing the motor, make sure that
the belt is hung on the gear and the pulley of
the motor securely.
Fig. 4-201
(3) Remove 2 screws and then take off the
registration motor.
Fig. 4-202
Drawer paper size
detection sensor-2
Drawer paper size
detection sensor-1
Registration motor
Registration motor