Toshiba e-studio 6560c - Sub-Hopper Toner Motor

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 102
4.6.14 Sub-hopper toner motor (K/C/M/Y) (M19/M20/M21/M22)
(3) Disconnect 1 connector and take off the EPU
cover.
Fig. 4-297
(1) Take off the EPU cover.
 P. 4-101"4.6.13 EPU cover"
(2) Disconnect 1 connector and remove 2
screws. Then take off the motor bracket.
Notes:
The shape of the bracket for K differs from
those for Y, M and C.
Fig. 4-298
(3) Remove 2 screws and take off the sub-
hopper toner motor.
Notes:
Pay attention to the size (length) of the
screws. If incorrect ones are used, the motor
could be damaged.
Fig. 4-299
EPU cover
Motor bracket
Screw
Sub-hopper toner motor