e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 96
Notes:
1. When installing, place the drum cleaner
unit by keeping it horizontal. In e-
STUDIO6550C/6570C, make sure to
install the correct position since it differs
depending on whether there is the V0
sensor or not.
2. Confirm that the unit is placed horizontally
by holding 4 sections (shown in the
figure) securely and checking that no
lifting is found at each section.
3. When installing the drum cleaner unit, be
sure that the orange label attached on the
shutter is clearly seen.
Fig. 4-278
Fig. 4-279
Fig. 4-280
Notes:
The respective colors are separate in the
drum cleaner unit.
Only the location with the same color as the
EPU tray cannot be installed.
When installing, check that the colors match.
[1] Black, [2] Blue, [3] Peach, [4] Yellow.
Fig. 4-281
Shutter Close Shutter Open
Label
To Next Page
Loading...
