Toshiba e-studio 6560c - Page 1278

Input check (Test mode 03)
Items to be checked and the condition of the equipment when the buttons [A] to [H] are highlighted are
listed in the following pages.
[FAX] button: OFF/[COPY] button: OFF/[SCAN] button: OFF
([FAX] LED: OFF/[COPY] LED: OFF/[SCAN] LED: OFF)
Highlighted display Normal display
e.g. e.g.
A Bridge unit path exit sensor Paper present No paper
B Bridge unit path entrance sensor Paper present No paper
C Reverse sensor Paper present No paper
D - - -
E Upper paper exit sensor Paper present No paper
F - - -
G - - -
H - - -
A - - -
B Fuser roller temperature abnormality Normal Excessively high
C Fuser transport sensor No paper Paper present
D
Thermopile wire breaking detection
signal
Normal Broken
E Fusing control abnormality Normal Abnormal
F - - -
G - - -
H - - -
A - - -
FIL board power cable detection signal
(Detecting the number of cables)
C - - -
D
- - -
E - - -
F
Pressure roller contact/release
detection sensor
Released Contacted
G - - -
H Fuser roller rotation detection Rotated Damaged or stopped
A - - -
B Registration sensor Paper present No paper
C Lower paper exit sensor Paper present No paper
D Sub-hopper toner motor-K locking Rotated Locked or stopped
E Sub-hopper toner motor-C locking Rotated Locked or stopped
F Sub-hopper toner motor-M locking Rotated Locked or stopped
G Sub-hopper toner motor-Y locking Rotated Locked or stopped
H - - -
A Polygonal motor ready signal No Ready (Stopped) Ready (Rotated)
Cover closed Cover opened
(24 V normal) (24 V abnormal)
C
Developer unit mixer motor-K locking
signal
Abnormal Normally rotated
D
Developer unit mixer motor-YMC
locking signal
Abnormal Normally rotated
E
TRU waste toner amount detection
sensor
Toner bag full Not full
F - - -
G
TRU waste toner motor locking
detection
Rotated Locked or stopped
Released Contacted
(home position) (No blocking)
Contents
[1]
[2]
Interlock switch
H
Transfer belt contact / release detection
sensor
Digital
key
Button Items to check
[3]
B 1 cable 2 cables
[4]
[5]
B