Toshiba e-studio 6560c - Page 1285

A Reverse path cover switch Cover opened Cover closed
B
Stopper opening/closing detection
sensor (front)
Stopper opened Stopper closed
C
Stopper opening/closing detection
sensor (rear)
Stopper opened Stopper closed
D - - -
Detecting connection between bridge
unit and drawers
(Refer to table 6)
F
Reverse section paper transport
detection sensor
Paper present No paper
G
Standby side tray paper amount
detection sensor
No paper Paper present
H Feed cover sensor Cover closed Cover opened
A 4th drawer bottom sensor Bottom position Normal
B 3rd drawer bottom sensor Bottom position Normal
C 2nd drawer bottom sensor Bottom position Normal
D 1st drawer bottom sensor Bottom position Normal
E
4th drawer tray-up sensor / End fence
home position sensor
Upper limit position /
Tray initial position
Normal
F 3rd drawer/tandem LCF tray-up sensor Upper limit position Normal
G 2nd drawer tray-up sensor Upper limit position Normal
H 1st drawer tray-up sensor Upper limit position Normal
A - - -
B - - -
C - - -
D Security enabler Connectable Not connectable
E
Judgement for acceptable USB storage
device (*1)
Acceptable Not acceptable
F - - -
G - - -
H - - -
*1
- Be sure to install the USB storage device to the equipment and check if the device can be used
with this code.
- Be sure to turn OFF the write protection (the function to prevent data from erasure by the accidental
recording or deleting) of the USB storage device before performing the check, otherwise this code
cannot be used.
- It may take some time (2 sec. to 10 sec.) before this check is completed depending on the USB
storage device.
[9]
[0]
[8]
E OFF (H) ON (L)