e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 44
(2) Remove 3 screws and take off the polygonal
motor cover.
Fig. 4-123
Notes:
1. Treat the polygonal motor gently.
2. Never touch the surface of the polygonal
mirror or glass.If you do so, wipe the dirt
off using a clean and soft cloth, taking
care not to scratch the surface.
Fig. 4-124
(3) Disconnect 1 connector, remove 4 screws
and then take off the polygonal motor.
Notes:
1. Check that all 4 fixing screws for the
polygonal motor contact the base before
fixing the motor.
2. When installing the polygonal motor,
neither hold the condenser (element) on
the board nor damage the mirror with a
screwdriver.
Fig. 4-125
To Next Page
Loading...
