e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 58
(4) Remove 1 screw and then take off the
bracket.
Fig. 4-165
(5) Disconnect 1 connector and remove 1 screw.
Then take off the sensor cover.
Fig. 4-166
(6) Remove 1 E-ring and the gear.
Notes:
When assembling the unit, pay attention to
the orientation of the gear.
Fig. 4-167
(7) Remove 4 screws, and then take off the
paper guide D.
Notes:
When reassembling, make sure the boss of
the paper guide is securely inserted into the
hole of the plate.
Fig. 4-168
To Next Page
Loading...
