Toshiba e-studio 6560c - Page 247

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 73
4.5.43 3rd drawer transport clutch (CLT4)/3rd drawer feed clutch (CLT5)
(e-STUDIO5560C/6560C/6570C)
(1) Take off the paper feed drive unit.
 P. 4-72"4.5.41 Paper feed drive unit"
(2) Remove 2 screws and take off the bracket[1].
Fig. 4-212
(3) Disconnect 1 connector[1].
Remove 1 bushing[4] and 2 clips[3].
Take off the 3rd drawer transport clutch[2].
(4) Disconnect 1 connector[5].
Remove 1 bushing[4] and 2 clips[3].
Take off the 3rd drawer feed clutch[6].
Fig. 4-213
Notes:
• When installing, be sure to align the
protrusion of the clutch to the position
shown in the figure.
• The color of the harnesses for the drawer
transport clutch and for the drawer feed
clutch is different. When installing, be
sure to attach the corresponding harness.
Black: 3rd drawer transport clutch[1]
Red: 3rd drawer feed clutch[2]
Fig. 4-214
[1]
[1]
[2]
[3]
[4]
[3]
[4]
[5]
[6]
[2]
[1]