e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 170
h. Be careful not to catch the harnesses for the fuser belt thermostat, rotating detection sensor and the
edge thermistor in the cover.
i. Be sure to pass the harnesses for the fuser belt rotating detection sensor through the brown clamps.
j. Be sure to pass the harnesses for the fuser belt thermostat through 2 clamps and pull the harnesses
out to the outer side of the frame. In addition, wire the harness at the holder section as shown below.
To Next Page
Loading...
