Toshiba e-studio 6560c - Page 496

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
5 - 12
Procedure 7
* When the automatic adjustment ends abnormally, an error message is displayed.
* Return to standby screen by pressing the [CANCEL] or [CLEAR] button.
Procedure 10
Procedure 12
Procedure 14
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[Digital key]
(Sub code)
[CLEAR]
(Corrects value)
[START][START]
*[CANCEL] or [CLEAR]
[CANCEL]
[FAX]
[START]
(Test copy)
[OK]
Stores value
in RAM
Automatic
adjustment
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[Digital key]
(Sub code)
[START] [START][START]
[OK] or [INTERRUPT]
(Value unchangeable)
Value
displayed
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[START]
[CANCEL]
[Digital key]
(Key in a value)
[CLEAR]
(Corrects value)
[OK]
or
[INTERRUPT]
(Stores value in RAM)
[FAX]
[START]
(Test copy)
Manual
adjustment
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[START]
[START]
[Digital key]
(Sub code)
[FUNCTION CLEAR]
(Corrects value)
[CLEAR]
(Corrects value)
[OK]
or
[INTERRUPT]
[FAX]
[START]
(Test copy)
[UP] or [DOWN]
(Adjust a value)
Stores value
in RAM