5
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
SELF-DIAGNOSTIC MODE
5 - 25
When “2” is selected, the menu below appears.
To start, press the [START] button.
Fig.5-12
When the operation is finished, the result appears on the menu.
Fig.5-13
Note:
After this operation, the equipment becomes reusable without reinstalling the firmware.
HDD Assist Mode
Current HDD type: ADI HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
2. Remove key
System Firmware Version
Update Mode
: xxxx(x.x.x.x)
: 4c Mode
=>
Confirmation Screen
Are you sure ???
Press START to continue
Press STOP to cancel
HDD Assist Mode
Current HDD type: ADI HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
2. Remove key
System Firmware Version
Update Mode
: xxxx(x.x.x.x)
: 4c Mode
=>
Data in the HDD has been erased.
Press SoftPower Key to Switch Off
To Next Page
Loading...
