e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
8 - 94
[EA50] Stapling jam
[EA60] Early arrival jam
Finisher controller board • Connector check(CN16)
• Board check
Replace parts Remarks
Front cover switch (SW1)
Stationary tray opening/closing
switch (SW2)
Finisher controller board
Classification Error item
Finisher jam
(Finisher section)
[MJ-1103/1104]
Check item Measures
Finisher • Check if there is any paper in the finisher or on the
transport path of the equipment and remove it if there is.
• Is the jam cleared by taking off the staple cartridge from
the finisher and removing the staple sheet slid from the
staple case?
Stapler interference sensor (S11) • Sensor check
• Connector check
• Harness check
Finisher controller board • Connector check(CN2)
• Board check
Replace parts Remarks
Stapler interference sensor (S11)
Finisher controller board
Classification Error item
Finisher jam
(Finisher section)
The inlet sensor detects the paper earlier than a specified
timing. [MJ-1103/1104]
Check item Measures
Finisher • Check if there is any paper in the finisher or on the
transport path of the equipment and remove it if there is.
Entrance sensor (S1) • Sensor check
• Connector check
• Harness check
Finisher controller board • Connector check(CN7)
• Board check
Replace parts Remarks
Entrance sensor (S1)
Finisher controller board
Check item Measures
To Next Page
Loading...
