e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
8 - 110
[EF24] Hole Punch Unit paper leading skew detection abnormality
[EF25] Hole Punch Unit paper leading edge detection abnormality
Punch controller board • Connector check
• Board check
Replace parts Remarks
Sideways deviation home position
sensor (S3)
Sideways adjustment motor (M2)
Punch controller board
Classification Error item
Finisher jam (Saddle section)
Check item Measures
Finisher • Is there any paper remaining on the paper transport path?
Is it staying at the position shown below?
• Figure out the cause of the paper stopping (e.g. folding)
and correct it. Then remove the paper.
Skew sensor (S7-1/S7-2) • Sensor check
• Connector check
• Harness check
Punch controller board • Connector check (CN19)
• Board check
Replace parts Remarks
Skew sensor (S7-1/S7-2)
Punch controller board
Classification Error item
Finisher jam (Saddle section)
Check item Measures
Skew sensor
(S7-1, S7-2)
Skew sensor
(S7-1, S7-2)
Paper position
sensor (S6-1, S6-2)
Paper Paper
To Next Page
Loading...
