Toshiba e-studio 6560c - Page 906

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
8 - 150
[CBC0] Alignment motor abnormality
[CBE0] Paper folding motor abnormality
Classification Error item
Finisher related service call Alignment motor is not rotating or aligning plate is not moving
normally. [MJ-1103/1104]
Check item Measures
Alignment plate home position
sensor (PI5)
• Sensor check
• Connector check
• Harness check
Alignment motor (M5) • Motor check
• Connector check
• Harness check
Alignment plate drive mechanism • Is the alignment plate drive mechanism normal?
Saddle control PC board (SDL) • Connector check
• Board check
Replace parts Remarks
Alignment plate home position
sensor
Alignment motor
Saddle control PC board
Classification Error item
Finisher related service call Paper folding motor or paper folding roller is not rotating
normally. [MJ-1103/1104]
Check item Measures
Paper folding motor clock sensor
(PI4)
• Sensor check
• Connector check
• Harness check
Paper folding home position sensor
(PI21)
• Sensor check
• Connector check
• Harness check
Paper folding motor (M2) • Motor check
• Connector check
• Harness check
Paper folding roller drive mechanism • Is the paper folding roller drive mechanism normal?
Saddle control PC board (SDL) • Connector check
• Board check
Replace parts Remarks
Paper folding motor clock sensor
Paper folding home position sensor
Paper folding motor
Saddle control PC board