e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
8 - 184
[CEC5] Incorrect cam position alarm during 2nd transfer
Classification Error item
Copy process related service call Printing is finished even though the cam is stopped at an
incorrect position during 2nd transfer pressure reduction.
When this alarm occurs 3 times in total, the 2nd transfer
pressure reduction is disabled (the value of 08-4663 is
automatically turned to “0” from “1”). (The number of
occurrences is stored in 08-4664.)
Step Check Item Result Measure
Next
Step
1
2nd transfer contact/release cam
unit gear
Check that it is not damaged.
2
Actuator in the TRU • Check that it is installed properly.
• Check that it is not damaged.
3
Sensors in the TRU • Check that they are installed
properly.
• Check that the cam is not
damaged.
4
If any abnormality on a part is
detected and the part is replaced,
the 2nd transfer pressure
reduction is enabled by changing
the value of the setting codes as
follows:
08-4663: 0 to 10: Pressure
reduction disabled1: Pressure
reduction enabled
08-4664: 3 to 0Resetting incorrect
cam position error count
Notes:
Change the value of the following codes to disable the pressure reduction:
08-4663: 1 to 0
0: Pressure reduction disabled
1: Pressure reduction enabled
08-4664: 0, 1 or 2 to 3
Resetting incorrect cam position error count
Replace parts Remarks
Actuator in the TRU
Sensors in the TRU
To Next Page
Loading...
