e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
8 - 220
[2B31] Status of specified Electronic Filing or folder is undefined or being created/deleted
[2B50] Image library error
[2B90] Insufficient memory capacity
Check item Measures
Setting • Erase some data in the Electronic Filing or the shared
folder and perform the job in error again (in case of
[2B30]).
• Turn the power OFF and then back ON. Perform the job in
error again.
• Check that there is no other job in progress, and format
the HDD with [5] + [C] + [POWER].
• If the recovery is still not completed, replace the SYS
board.
Replace parts Remarks
SYS board
Classification Error item
Electronic Filing related error
Check item Measures
Setting • Check if the specified Electronic Filing or folder exists. (If
no, this error would not occur.)
• Delete the specified Electronic Filing or folder.
• Perform the job in error again.
• If the specified box/folder cannot be deleted, initialize the
Electronic Filing with [5] + [C] + [POWER].
Replace parts Remarks
Classification Error item
Electronic Filing related error
Check item Measures
Setting • Turn the power OFF and then back ON. Perform the job in
error again.
• If the error still occurs, replace the main memory.
• Delete the job in progress or being set or in the HOLD/
PRIVATE/PROOF/INVALID, and retry the job in error.
• Check that there is no other job in progress, and initialize
the Electronic Filing with [5] + [C] + [POWER].
Replace parts Remarks
To Next Page
Loading...
