UTT Technologies Wireless Menu
http://www.uttglobal.com Page 60
Device A.
2） The IP address of LAN port of Device B is in the same network segment as
the LAN port address of Device A.
Step 6 Connectivity verification
To test connectivity, you can log into a computer that is connected to Device B, and
use the ping command to ping the LAN IP address of the Device A. If the ping is
successful, a wireless connection between the two devices has been established.
After Device B is connected to Device A wirelessly, the client devices connected to
Device B are able to access the Internet.
Solutions II, III, IV, V can follow Solution I.
Notes:
1） The Device in Bridge Mode cannot be connected to the single wireless clients,
such as laptops, smartphones, etc.
2） The Devices in Lazy Mode can be connected to the single wireless clients.
3） In configuration, the SSID, Wireless Mode, Channel, Channel Width, Security
Mode and Pre-shared Key of Devices A, B must be kept consistent, and the MAC
address of AP is that of the peer device (It is not required to configure the MAC
address of the peer device when the AP mode is Lazy Mode).
4） Device A and B must be in the same network segment.
To Next Page
Loading...
