Vaisala WXT530 Series - Checking the Settings (aRU)

1
Transducer id for average wind speed
S
Transducer id 2 type (wind speed)
0.2
Transducer id 2 data (max wind speed)
M
Transducer id 2 units (m/s, max wind speed)
2
Transducer id for max wind speed
*
Checksum delimiter
57
Two-character checksum for the response
<cr><lf>
Response terminator
The structure of the pressure, temperature and humidity sensor response message:
$
Start of the message
WI
Device type (WI = weather instrument)
XDR
Transducer measurement response identifier
C
Transducer id 0 type (Temperature), see the following Transducer table
23.3
Transducer id 0 data (Temperature)
C
Transducer id 0 units (C, Temperature)
0
Transducer id for Temperature
C
Transducer id 1 type (temperature)
23.3
Transducer id 1 data (Tp internal temperature)
C
Transducer id 1 units (C, Tp internal temperature)
1
Transducer id for Tp internal temperature
H
Transducer id 0 type (Humidity)
50.1
Transducer id 0 data (Humidity)
P
Transducer id 0 units (%, Humidity)
0
Transducer id for Humidity
P
Transducer id 0 type (Pressure)
1009.1
Transducer id 0 data (Pressure)
H
Transducer id 0 units (hPa, Pressure)
0
Transducer id for Pressure
*
Checksum delimiter
75
Two-character checksum for the response
<cr><lf>
Response terminator
The structure of the precipitation sensor response message:
WXT530 Series User Guide M211840EN-D
110
sales@streamlinemeasurement.co.uk
01457-864334
www.streamlinemeasurement.co.uk