Vanderbilt SPC42 Series User Manual

EN50131 Requirement (and relevant section) Relevant Vanderbilt documentation
Programmable functions provided Engineer programming via the keypad on
page112
Engineer programming via the browser on
page172
How indications are made inaccessible to level 1 users when
level 2, 3 or 4 user is no longer accessing the information (see
8.5.1)
Keypad user interface on page93
LCD Keypad Settings on page126
Comfort Keypad Settings on page127
Configuring an Indicator Expander on page240
Masking/reduction of range signals/messages processed as
“fault” or “masking” events (see 8.4.1, 8.5.1 and Table 11)
System Options on page252
Wiring the zone inputs on page85
SIA Codes on page368
PIR masking is always reported as a zone
masked event (SIA - ZM). Additionally, anti-
mask can cause an alarm, tamper, trouble or no
additional action depending on configuration
Current defaults of PIR addition effect:
Ireland
Unset - None
Set - Alarm
UK, Europe, Sweden, Swiss, Belgium
Unset - Tamper
Set - Alarm
Prioritization of signal and message processing and indications
(see 8.4.1.2, 8.5.3)
Using the LCD keypad interface on page95
Using the Comfort keypad interface - see About
the Comfort keypad on page99
Minimum number of variations of PIN codes, logical keys,
biometric keys and/or mechanical keys for each user (see 8.3)
User PIN combinations on page376
Method of time-limiting internal WD for level 3 access without
level 2 authorization (see 8.3.1)
Not supported - Engineer cannot access system
without permission.
Number and details of disallowed PIN codes (see 8.3.2.2.1) Automatic inhibits on page376
Details of any biometric authorization methods used (see
8.3.2.2.3)
Not applicable
Method used to determine the number of combinations of PIN
codes, logical keys, biometric keys and/or mechanical keys
(see 11.6)
User PIN combinations on page376
Number of invalid code entries before user interface is disabled
(see 8.3.2.4)
Access PINs on page377
Details of means for temporary authorization for user access
(see 8.3.2)
User Menus – Grant Access
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Directives and standards
© Vanderbilt 2018 17 A6V10276959-d
11.2018

Vanderbilt SPC42 Series Specifications

General

Brand	Vanderbilt
Model	SPC42 Series
Category	Power Supply
Language	English