Attribute Description
Extended
Time
Extend door timers when this card is present.
PIN
bypass
Access a door without PIN on a door with PIN reader.
Priority Priority cards are stored locally in the door controllers and will grant access in case of a technical fault
where the door controller cannot communicate with the control panel.
The maximum number of priority users is:
l SPC4xxx – all users
l SPC5xxx – 512
l SPC6xxx – 512
Escort The escort feature enforces privileged card holders to escort other card holders through specific doors.
If this feature is enabled on a door, a card with the “escort” right has to be presented first, to allow other
cardholders without this right to open the door. The time period in which cardholders are able to
present their cards after a card with escort right was presented, can be configured per door.
Custodian The custodian feature enforces a card holder with custodian privilege to always be inside a room (door
group) when other card holders are inside.
The custodian must be the first to enter the room. Only if a custodian is in the room other cardholders
are allowed to enter. The cardholder with the custodian right will not be allowed to exit until all non-
custodian cards left the room.
Identifies this card holder as a custodian. The user with the custodian attribute has to be the first who
enters a door group which requires a custodian card holder and has to be the last that is leaving this
door group.
17.8.1.1 Unknown Devices
If an unknown device, such as a fob, PACE, or card, has been scanned but not assigned to a user, a
button is displayed in the relevant section of the edit user settings page.
l RF- FOB – Unknown Fob button or, if the device is assigned to the user, Delete FOB button
l Pace – Unknown Pace button or, if the device is assigned to the user, Delete Pace button
l Access Control – Unknown card button
To assign a fob, PACE or card to the user:
1. Click the Unknown button for the device. The User page displays the list of unknown devices.
2. Click Add to assign the device to the user.
Note: To assign a card to the user, the associated user profile must have the correct site code defined.
To unassign a fob or Pace from a user:
1. Click the Delete button.
The device is unassigned from the user and also deleted from the system.
2. To add the device again, you must rescan it.
To unassign a card from a user:
1. Change the card number to zero (0).
2. Click Save.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 198 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
