July 29, 2013, 715003794 Rev. B xiii
2 Install the e2695 Separations Module ................................................ 45
Installation overview ........................................................................................ 45
Site requirements .............................................................................................. 46
Firmware and software requirements .......................................................... 47
Unpack .................................................................................................................. 48
Connect to the electrical power supply ........................................................ 48
Connect tubing and attachments ................................................................... 50
Install B-series detector base and drip tray..................................................... 50
Install A and C series drip tray and support bracket...................................... 53
Install solvent supply tubing............................................................................. 58
Install the degasser vent tubing ....................................................................... 59
Make waste line connections............................................................................. 60
Install needle-wash and plunger seal-wash reservoirs.................................... 61
Connect the column ........................................................................................... 62
Connect the column selection valve.................................................................. 64
Connect the detector.......................................................................................... 68
Signal connections ............................................................................................. 69
I/O signal connections........................................................................................ 71
Digital signal connections ................................................................................. 75
Add hardware options ...................................................................................... 78
Install an optional sample loop ......................................................................... 78
Install the column heater and column heater/cooler ....................................... 81
Install a syringe ................................................................................................. 81
3 Prepare the e2695 Separations Module for Operation .................. 83
Power-on the separations module ................................................................. 83
Startup diagnostic tests..................................................................................... 83
The Main screen................................................................................................. 84
Operating overview ........................................................................................... 84
Screen display overview .................................................................................... 85
Use the keypad................................................................................................... 86
To Next Page
Loading...
