HANDLEBARS
4-64
NOTE:
• Install the clutch master cylinder holder with
the “UP” mark facing up
• Align the mating surfaces of the clutch master
cylinder holder with the punch mark “a” on the
left handlebar.
• First, tighten the upper bolt, then the lower bolt.
11.Adjust:
• Throttle cable free play
Refer to “ADJUSTING THE THROTTLE CA-
BLE FREE PLAY” on page 3-8.
T
R
.
.
Clutch master cylinder holder
bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
Throttle cable free play
3.0–5.0 mm (0.12–0.20 in)
To Next Page
Loading...
