FUEL INJECTION SYSTEM
8-54
08 Lean angle sensor Remove the lean angle
sensor and incline it more
than 65 degrees.
• Upright 0.4–1.4
• Overturned 3.7–4.4
09 Fuel system voltage
(battery voltage) Approximately 12.0
Set the engine stop switch
to “”, and then compare
with the actually measured
battery voltage. (If the bat-
tery voltage is lower, per-
form recharging.)
20 Sidestand switch Set on/off the Sidestand
switch. (with the transmis-
sion in gear.)
• Stand retracted ON
• Stand extended OFF
21 Gear position switch Shift the transmission.
• Neutral ON
• In gear OFF
60 EEPROM fault code dis-
play
—
• No history 00
• History exists 01–04 (Cylinder fault code)
• (If more than one cylinder is
defective, the display alter-
nates every two seconds to
show all the detected cylin-
der numbers. When all cyl-
inder numbers are shown,
the display repeats the
same process.)
61 Malfunction history code
display
—
• No history 00
• History exists Fault codes 11-50
• (If more than one code
number is detected, the dis-
play alternates every two
seconds to show all the de-
tected code numbers.
When all code numbers are
shown, the display repeats
the same process.)
Diag-
nostic
code
No.
Item Meter display Checking method
To Next Page
Loading...
