FUEL INJECTION SYSTEM
8-55
*1 If it is not possible to check the intake temperature, use the ambient temperature as reference (use
the compared values for reference).
Actuator operation table
62 Malfunction history code
erasure
• No history 0 —
• History exists • Displays the total number of
malfunctions, including the
current malfunction, that
have occurred since the
history was last erased.
(For example, if there have
been three malfunctions,
“03” is displayed.)
To erase the history, set the
engine stop switch from
“” to “”.
70 Control number 0–255 —
Diag-
nostic
code
No.
Item Actuation Checking method
30
Cylinders-#1/#4 ignition
coil
Actuates the cylinders-#1/#4
ignition coil five times at one-
second intervals.
Illuminates the engine trou-
ble warning light.
Check the spark five times.
• Connect an ignition
checker.
31
Cylinders-#2/#3 ignition
coil
Actuates the cylinders-#2/#3
ignition coil five times at one-
second intervals.
Illuminates the engine trou-
ble warning light.
Check the spark five times.
• Connect an ignition
checker.
36 Injector #1
Actuates the injector #1 five
times at one-second inter-
vals.
Illuminates the engine trou-
ble warning light.
Check the operating sound
of the injector #1 five times.
37 Injector #2
Actuates the injector #2 five
times at one-second inter-
vals.
Illuminates the engine trou-
ble warning light.
Check the operating sound
of the injector #2 five times.
38 Injector #3
Actuates the injector #3 five
times at one-second inter-
vals.
Illuminates the engine trou-
ble warning light.
Check the operating sound
of the injector #3 five times.
Diag-
nostic
code
No.
Item Meter display Checking method
To Next Page
Loading...
