Yamaha XVS650 - CLUTCH

CLUTCH
ENG
NOTE: _
• Apply engine oil onto the friction plates.
• Align the
two slots ® on the friction
plates with the two punch marks (S) on the
clutch housing.
**********************************
4.1nstall:
• Push rod
#2
• Ball
• Push rod
#1 CD
.O-ring® _
• Push plate
@
• Washer@
• Nut®
NOTE: _
Apply lithium soap base grease onto the
push rod and the ball.
5.1nstall:
• Pressure plate
CD
• Clutch springs ®
• Bolts@ ~-8-N-m-(-o.-8-m-.-k-g,-5-.8-ft-.I-b)-
NOTE: _
Tighten the pressure plate bolts in stages,
using a crisscross pattern.
6.Check:
• Push lever position
• Push the push lever assembly in the direc-
tion
of the arrow and make sure that the
match marks are aligned.
Match marks
not aligned. ~ Adjust.
® Match mark on the push lever assembly
(6) Match mark on the crankcase
7.Adjust:
• Push lever position
**********************************
Adjustment steps:
• Loosen the
nut CD.
• Turn the push rod #1 ® clockwise or
counterclockwise so that the match marks
are aligned.
• Tighten
the nut CD.
~ Nut (clutch adjuster):
~~ 8 Nm (0.8 m • kg, 5.8 ft • Ib)
4-41 **********************************