MIDDLE GEAR
ENG
tt>.
7.1nstall:
• Bearings
CD
(onto the cross joint)
The needles can easily fall
out
of
their
races, so check each bearing. Slide
the
uni-
versal
joint
yoke
back and
forth
on
the
bearings.
If
a needle
is
out
of
place
the
yoke
will
not
go
all
the
way
onto
the
bear-
ing.
8.Using a suitable socket press each bear-
ing into the hole on yoke.
NOTE:
_
The bearings
must
be inserted
far
enough
into the cross
joint
so
that
the circlips can
be installed.
9.lnstall:
• Circlips
®
(into the groove
of
each bearing)
10.lnstall:
• Middle driven pinion gear assembly
NOTE:
_
Just
finger
tighten the bolts at
this
stage.
NOTE:
_
When installing the shims, make sure
that
the tabs ® are positioned correctly.
4 - 77
11.1nstall:
• Shims
CD
• Bolts
~25
Nm
(2.5
m . kg,
18.1
ft
. Ib) I
To Next Page
