Yealink T21PE2 - Label Length Display Configuration; Label Alignment for LineExt Key Display; Label Alignment Display Configuration

Phone Customization
115
Label Length Display Configuration
The following table lists the parameters you can use to configure the label length display.
Parameter features.config_dsskey_length <y0000000000xx>.cfg
Description
It configures the label length displayed on the idle LCD screen for the line key.
Note: It is only applicable to T54S/T48S/T48G/T46S/T46G/T29G IP phones.
Permitted
Values
0-Default
1-Extended
2-Mid Range (only applicable to T54S/T46S/T46G/T29G IP phones)
Default 0
Web UI Dsskey->Line Key->Label Length
Parameter features.shorten_linekey_label.enable <y0000000000xx>.cfg
Description
It enables or disables the IP phone to display the length of the line key label within 9 digits.
Note: It works only if “features.config_dsskey_length” is set to 0 (Default). It is only applicable to
T54S/T52S/T48S/T48G/T46S/T46G/T29G IP phones.
Permitted
Values
0-Disabled, the line key label can display at most 8 digits.
1-Enabled, the line key label can display at most 9 digits.
Default 0
Label Alignment for Line/Ext Key Display
You can customize the line/ext key label alignment.
This feature is only applicable to T52S/T54S/T46S/T46G/T29G IP phones and expansion module EXP50 (connected to
the T54S/T52S IP phones).
The following figures show the line key label alignment on T46S/G IP phones:
Topic
Label Alignment Display Configuration
Label Alignment Display Configuration
The following table lists the parameter you can use to configure the label alignment display.
Parameter phone_setting.dsskey_label.display_method <y0000000000xx>.cfg