Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
138
Parameter features.key_as_send <y0000000000xx>.cfg
Description It configures the "#" or "*" key as the send key.
Permitted
Values
0-Disabled, neither “#” nor “*” can be used as the send key.
1-# key, the pound key is used as the send key.
2-* key, the asterisk key is used as the send key.
Default 1
Web UI Features->General Information->Key As Send
Phone UI
T54S/T52S/T48S/T48G/T46S/T46G/T29G:
Menu->Features->Others->General->Key As Send
T42G/T42S/T41P/T41S/T40P/T40G/T27G/T23P/T23G/T21(P) E2/T19(P) E2/CP920:
Menu->Features->Key As Send
Parameter features.send_pound_key <y0000000000xx>.cfg
Description
It configures the behavior when the user presses the # key twice on the dialing screen.
Note: It works only if “features.key_as_send” is set to 1 (Enabled).
Permitted
Values
0-The IP phone will dial out “#”.
1-The IP phone will not dial out “#”. After the user presses the # key again, the IP phone will dial out “##”.
Default 0
Web UI Features->General Information->Send Pound Key
Softkey Layout
Softkey layout is used to customize the soft keys at the bottom of the phone screen for best meet users’ requirements.
In addition to specifying which soft keys to display, you can determine their display order. The configurations for
softkey layout are based on call states.
The following shows the soft keys displaying on the phone in the dialing state:
Note
You can configure the EDK soft keys in different call states. Configuring the EDK soft keys may affect the softkey layout in
different call states. For more information on EDK soft keys, refer to EDK Soft Keys Configuration.
Topics
To Next Page
Loading...
