Yealink T21PE2 - BLF Key LedIcon and Behavior for Talking State Configuration

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
426
Default Blank
Parameter blf.enhanced.callout.callin.action <y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is ringing and monitored
user is calling out.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.callout.callin.action = newcall
Note: It works only if “blf.enhanced.callout.enable” is set to 1 (Enabled). It is not applicable to T19(P)
E2/CP920 IP phones.
Permitted
Values
String
Default Blank
Parameter blf.enhanced.callout.talking.action <y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is talking and monitored
user is calling out.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.callout.talking.action = newcall
Note: It works only if “blf.enhanced.callout.enable” is set to 1 (Enabled). It is not applicable to T19(P)
E2/CP920 IP phones.
Permitted
Values
String
Default Blank
Parameter blf.enhanced.callout.idle.action <y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is idle and monitored
user is calling out.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.callout.idle.action = newcall
Note: It works only if “blf.enhanced.callout.enable” is set to 1 (Enabled). It is not applicable to T19(P)
E2/CP920 IP phones.
Permitted
Values
String
Default Blank
BLF Key LED/Icon and Behavior for Talking State Configuration
The following table lists the parameters you can use to configure BLF key LED/icon and Behavior for talking state (the
monitored user is talking).