Yealink T21PE2 - Area Code Configuration

Call Features
263
Values
Default Blank
Parameter dialplan.transfer.mode <y0000000000xx>.cfg
Description
It configures the transfer type the IP phone will perform when the entered transferee numbers match the
Dial Now rule of the dial plan.
Note: It is only applicable to the old dial plan mechanism.
Permitted
Values
0-Semi-attended Transfer/Attended Transfer
1-Blind Transfer
Default 0
[1]
X is from 1 to 100.
Area Code Configuration
The following table lists the parameters you can use to configure area code.
Parameter dialplan.area_code.code <y0000000000xx>.cfg
Description
It configures the area code to be added before the entered numbers when dialing out.
Example:
dialplan.area_code.code = 0592
Note: The length of the entered number must be between the minimum length configured by the para-
meter “dialplan.area_code.min_len” and the maximum length configured by the parameter “dialplan.area_
code.max_len”. It works only if “dialplan.digitmap.enable” and “account.X.dialplan.digitmap.enable” are
set to 0 (Disabled).
Permitted
Values
String within 16 characters
Default Blank
Web UI Settings->Dial Plan->Area Code->Code
Parameter dialplan.area_code.min_len <y0000000000xx>.cfg
Description
It configures the minimum length of the entered number.
Note: It works only if “dialplan.digitmap.enable” and “account.X.dialplan.digitmap.enable” are set to 0
(Disabled).
Permitted
Values
Integer from 1 to 15
Default 1
Web UI Settings->Dial Plan->Area Code->Min Length (1-15)
Parameter dialplan.area_code.max_len <y0000000000xx>.cfg
Description
It configures the maximum length of the entered number.
Note: The value must be larger than the minimum length. It works only if “dialplan.digitmap.enable” and
“account.X.dialplan.digitmap.enable” are set to 0 (Disabled).
Permitted
Values
Integer from 1 to 15