Configuration Parameters
505
If the user does not perform any operation for 10 seconds on Shared Calls screen, the IP phone will exit
the screen.
Note: You can enter the Shared Calls screen by long pressing the shared line key when there is a call on
the remote shared line party. It is not applicable to T19(P) E2/CP920 IP phones.
Permitted
Values
Integer from 0 to 2147483647
Default 10
[1]
X is the account ID. For T54S/T48S/T48G/T46S/T46G/T29G, X=1-16; for T52S/T42G/T42S, X=1-12; for T41P/T41S/T27G,
X=1-6; for T40P/T40G/T23P/T23G, X=1-3; for T21(P) E2, X=1-2.
Broadsoft Call Park
Parameter features.call_park.group_enable <y0000000000xx>.cfg
Description
It enables or disables the IP phone to display the GPark soft key during a call.
Note: If it is set to 1 (Enabled), the Retrieve soft key will also be displayed on the dialing screen.
Permitted
Values
0-Disabled
1-Enabled
Default 0
Web UI Features->Pickup & Park->Group Call Park (if bw.enable =1)
Parameter features.call_park.park_ring <y0000000000xx>.cfg
Description
It enables or disables the IP phone to play a warning tone when a call is parked against its line.
Note: It works only if “features.call_park.park_visual_notify_enable” is set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default 0
Web UI Features->Pickup & Park->Audio Alert for Parked Call (if bw.enable =1)
Parameter features.call_park.park_visual_notify_enable <y0000000000xx>.cfg
Description It enables or disables the IP phone to display a parked indicator when a call is parked against its line.
Permitted
Values
0-Disabled
1-Enabled
Default 0
Web UI Features->Pickup & Park->Visual Alert for Parked Call (if bw.enable =1)
Parameter features.call_park.group_park_code <y0000000000xx>.cfg
Description
It configures the group call park code for the GPark soft key.
This group call park code will also apply to the call park DSS key.
Note: It works only if “features.call_park.park_mode” is set to 1 (FAC).
Permitted
Values
String within 32 characters
Default Blank
To Next Page
Loading...
