Phone Customization
171
Ext Keys Configuration
The following table lists the parameters you can use to configure ext keys.
Parameter expkey.type_range.custom <y0000000000xx>.cfg
Description
It configures the list for available ext key types list when configuring ext keys.
To assign function types, specify ext key type IDs which start with or without a symbol ”+”. For example,
“+2,15,16,7,4” or “2,15,16,7,4” means only “N/A”, “Forward”, “Line”, “BLF”, “ReCall”, “Hold” types are avail-
able when you configure ext keys.
To remove a function type, specify ext key type IDs which start with the symbol “-”. For example, “-14, 5,
2” means to remove “Intercom”, “DND”, “Forward” types from the ext key types list. These ext key types
are not available when you configure ext keys.
Note: Multiple ext key type IDs are separated by commas. N/A type is always kept. It is only applicable to
T54S/T52S/T48S/T48G/T46S/T46G/T29G/T27G IP phones.
Permitted
Values
blank or 0 (all valid function types are available);
Dsskey type IDs.
For supported Dsskey types and IDs, refer to Supported Dsskey Types.
Default Blank
Parameter
expansion_module.X.key.Y.type
[1]
<y0000000000xx>.cfg
Description
It configures the feature for a specific ext key.
Note: It is only applicable to T54S/T52S/T48S/T48G/T46S/T46G/T29G/T27G IP phones.
Permitted
Values
0-N/A
1-Conference
2-Forward
3-Transfer
4-Hold
5-DND
7-ReCall
8-SMS
9-Direct Pickup
10-Call Park
11-DTMF
12-Voice Mail
13-Speed Dial
14-Intercom
15-Line
16-BLF
17-URL
18-Group Listening
20-Private Hold
22-XML Group
23-Group Pickup
24-Multicast Paging
(Paging)
25-Record
27-XML Browser
34-Hot Desking
35-URL Record
37-Switch (only applicable to ext key 1 for
T29G/T27G IP phones)
38-LDAP (only appears when “ldap.enable=1”)
39-BLF List
40-Prefix
41-Zero Touch
42-ACD
45-Local Group
50-Phone Lock
56-Retrieve Park
61-Directory
66-Paging List
73-Custom Key (only available when “fea-
tures.enhanced_dss_keys.enable=1”)
77-Mobile Account (only available to T52S/T54S IP
phones when the Bluetooth-Enabled mobile phone
is connected)
Note: The permitted values are configurable by “expkey.type_range.custom”.
Default Y = 1-40 or 1-60, default: 0 – NA
To Next Page
Loading...
