Yealink T21PE2 - BLF Key LedIcon and Behavior for Call-In State Configuration

Advanced Features
423
Parameter blf.enhanced.idle.callin.action <y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is ringing and monitored
user is idle.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.idle.callin.action = newcall
Note: It works only if “blf.enhanced.idle.enable” is set to 1 (Enabled). It is not applicable to T19(P)
E2/CP920 IP phones.
Permitted
Values
String
Default Blank
Parameter blf.enhanced.idle.talking.action <y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is talking and monitored
user is idle.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.idle.talking.action = newcall
Note: It works only if “blf.enhanced.idle.enable” is set to 1 (Enabled). It is not applicable to T19(P)
E2/CP920 IP phones.
Permitted
Values
String
Default Blank
Parameter blf.enhanced.idle.idle.action <y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor and monitored user are
idle.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.idle.idle.action = 1234$Tinvite$
Note: It works only if “blf.enhanced.idle.enable” is set to 1 (Enabled). It is not applicable to T19(P)
E2/CP920 IP phones.
Permitted
Values
String
Default Blank
BLF Key LED/Icon and Behavior for Call-in State Configuration
The following table lists the parameters you can use to configure BLF key LED/icon and Behavior for the call-in state
(the monitored user is ringing).
Parameter blf.enhanced.callin.enable <y0000000000xx>.cfg
Description It enables or disables the custom configuration when the monitored user is ringing.