Yealink T21PE2 - Example: Setting Call Park and Retrieve in FAC Mode

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
406
Default Blank
Web UI Features->Pick up & Park->Call Park Code
Parameter features.call_park.park_retrieve_code <y0000000000xx>.cfg
Description
It configures the park retrieve code for FAC call park mode, or configures retrieve parking lot for Transfer
call park mode.
Permitted
Values
String within 32 characters
Default Blank
Web UI Features->Pick up & Park->Park Retrieve Code
Parameter features.call_park.direct_send.enable <y0000000000xx>.cfg
Description
It enables or disables the IP phone to dial out the call park code/park retrieve code directly when pressing
the Park/Retrieve soft key. It is only applicable to FAC call park mode.
Note: It works only if “features.call_park.park_mode” is set to 1 (FAC) and you have configured the call
park code/park retrieve code. It is not applicable to CP920 IP phones.
Permitted
Values
0-Disabled, the IP phone will enter the pre-dialing screen when pressing the Park/Retrieve soft key. The
user can dial the specific extension manually or press the BLF/BLF List or Speed Dial key to park the call to
the specific extension or retrieve the call parked from the specific extension.
1-Enabled
Default 1
Parameter features.call_park.line_restriction.enable <y0000000000xx>.cfg
Description
It enables or disables the IP phone to park a call using the line specified by the parameter “linekey.X.line/-
expansion_module.X.key.Y.line”. It is only applicable to the scenario that the user uses the Park key to
park a call.
Note: It works only if “features.call_park.park_mode” is set to 2 (Transfer). It is not applicable to T19(P) E2
IP phones.
Permitted
Values
0-Disabled, the call is parked or retrieved by the current line. The current line is in call state.
1-Enabled, the call is parked or retrieved by the specific line.
Default 0
Example: Setting Call Park and Retrieve in FAC Mode
The following example shows the configuration for FAC call park mode.
Example
features.call_park.park_mode = 1
features.call_park.enable = 1
features.call_park.park_code = *68
features.call_park.park_retrieve_code = *88
After provisioning, the call park mode is set to FAC. A Park soft key will display on the phone during an active call, and
a Retrieve soft key will display on the Dialing screen. You can press the Park soft key to park a call, or press the
Retrieve soft key to retrieve a parked call.