Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
280
Values
1-Enabled, the phone will first dial out the pre-configured number (configured by the parameter “accoun-
t.X.auto_dial_num”).
Default 0
Parameter
account.X.auto_dial_num
[1]
<MAC>.cfg
Description
It configures the number that the IP phone first dials out when a user lifts the handset, presses the Speak-
erphone/off-hook key or desired line key, dials out a call using account X.
Note: It works only if “account.X.auto_dial_enable” is set to 1 (Enabled). Line key is not applicable to T19
(P) E2/CP920 IP phones; handset and Speakerphone key are not applicable to CP920 IP phones; off-hook
key is only applicable to CP920 IP phones.
Permitted
Values
String within 1024 characters
Default Blank
[1]
X is the account ID. For T54S/T48S/T48G/T46S/T46G/T29G, X=1-16; for T52S/T42G/T42S, X=1-12; for T41P/T41S/T27G,
X=1-6; for T40P/T40G/T23P/T23G, X=1-3; for T21(P) E2, X=1-2; for T19(P) E2/CP920, X=1.
Live Dialpad
Live Dialpad allows IP phones to automatically dial out the entered phone number without pressing the send key after
a designated period of time.
Topic
Live Dialpad Configuration
Live Dialpad Configuration
The following table lists the parameters you can use to configure live dialpad.
Parameter phone_setting.predial_autodial <y0000000000xx>.cfg
Description It enables or disables the live dialpad feature.
Permitted
Values
0-Disabled
1-Enabled, the IP phone will automatically dial out the entered phone number on the pre-dialing screen
without pressing a send key.
Default 0
Web UI Settings->Preference->Live Dialpad
Parameter phone_setting.inter_digit_time <y0000000000xx>.cfg
Description
It configures the delay time (in seconds) for the IP phone to automatically dial out the entered phone
number without pressing a send key.
Note: It works only if “phone_setting.predial_autodial” is set to 1 (Enabled).
Permitted
Values
Integer from 1 to 14
Default 4
Web UI Settings->Preference->Inter Digit Time (1~14s)
To Next Page
Loading...
