Yealink T21PE2 - Block out Configuration

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
264
Default 15
Web UI Settings->Dial Plan->Area Code->Max Length (1-15)
Parameter dialplan.area_code.line_id <y0000000000xx>.cfg
Description
It configures the desired line to apply the area code rule. The digit 0 stands for all lines. If it is left blank,
the area code rule will apply to all lines on the IP phone.
Note: Multiple line IDs are separated by commas. It works only if “dialplan.digitmap.enable” and “accoun-
t.X.dialplan.digitmap.enable” are set to 0 (Disabled). It is not applicable to T19(P) E2 IP phones.
Permitted
Values
0 to 16 (for T54S/T48S/T48G/T46S/T46G/T29G)
0 to 12 (for T52S/T42G/T42S)
0 to 6 (for T41P/T41S/T27G)
0 to 3 (for T40P/T40G/T23P/T23G)
0 to 2 (for T21(P) E2)
0, 1 (for CP920)
Default Blank
Web UI Settings->Dial Plan->Area Code->Account
Block Out Configuration
The following table lists the parameters you can use to configure block out.
Parameter
dialplan.block_out.number.X
[1]
<y0000000000xx>.cfg
Description
It configures the block out numbers.
Example:
dialplan.block_out.number.1 = 4321
When you dial the number “4321” on your phone, the dialing will fail and the phone screen will prompt
"Forbidden Number".
Note: It works only if “dialplan.digitmap.enable” and “account.X.dialplan.digitmap.enable” are set to 0
(Disabled).
Permitted
Values
String within 32 characters
Default Blank
Web UI
Settings->Dial Plan->Block Out->BlockOut NumberX
[1]
Parameter
dialplan.block_out.line_id.X
[1]
<y0000000000xx>.cfg
Description
It configures the desired line to apply the block out rule. The digit 0 stands for all lines. If it is left blank,
the block out rule will apply to all lines on the IP phone.
Note: Multiple line IDs are separated by commas. It works only if “dialplan.digitmap.enable” and “accoun-
t.X.dialplan.digitmap.enable” are set to 0 (Disabled). It is not applicable to T19(P) E2 IP phones.
Permitted
0 to 16 (for T54S/T48S/T48G/T46S/T46G/T29G)