Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
260
Dial Now File Attributes
The following table lists the attributes you can use to add dial-now rules to the dial now file:
Attributes Description
DialNowRule Specify the dial-now number.
LineID
Specify a registered line to apply the dial-now rule.
Valid Values: 0~16
0, 1 (for CP920)
0 stands for all lines;
1~16 stand for line1~line16 (Vary by phone models: T54S/T48S/T48G/T46S/T46G/T29G: 1~16;
T52S/T42G/T42S: 1~12; T41P/T41S/T27G: 1~6; T40P/T40G/T23P/T23G: 1~3; T21(P) E2: 1~2; CP920: 1)
Multiple line IDs are separated by commas.
Note: This is not applicable to T19(P) E2 IP phones.
Customizing the Dial Now File
1. Open the dial now file.
2. To add a dial-now rule, add <Data DialNowRule="" LineID="" /> to the file. Each starts on a new line.
3. Specify the values within double quotes.
For example,
<Data DialNowRule="1001" LineID="0" />
4. Save the changes and place this file to the provisioning server.
Replace Rule Configuration
You can configure replace rules either one by one or in batch using a replace rule template.
The following table lists the parameters you can use to configure replace rule.
Parameter
dialplan.replace.prefix.X
[1]
<y0000000000xx>.cfg
Description
It configures the entered number to be replaced.
Example:
dialplan.replace.prefix.1 =1
Note: It works only if “dialplan.digitmap.enable” and “account.X.dialplan.digitmap.enable” are set to 0
(Disabled).
Permitted
Values
String within 32 characters
Default Blank
Web UI Settings->Dial Plan->Replace Rule->Prefix
Parameter
dialplan.replace.replace.X
[1]
<y0000000000xx>.cfg
Description
It configures the alternate number to replace the entered number.
Example:
dialplan.replace.prefix.1 = 1 and dialplan.replace.replace.1 = 254245
To Next Page
Loading...
