Yealink T21PE2 - Call Forward in Custom Mode Configuration

Call Features
313
Note: It works only if “forward.no_answer.enable” or “account.X.timeout_fwd.enable” is set to 1
(Enabled).
Permitted
Values
Integer greater than or equal to 0
Default 6
Parameter forward.no_answer.on_code <y0000000000xx>.cfg
Description
It configures the no answer forward on code to activate the server-side no answer forward feature.
The IP phone will send the no answer forward on code and the pre-configured destination number (con-
figured by the parameter “forward.no_answer.target”) to the server when you activate the no answer for-
ward feature on a phone basis.
Note: It works only if “features.fwd.allow” is set to 1 (Enabled) and the value of the parameter “fea-
tures.fwd_mode” is set to 0 (Phone) (except T19(P) E2/CP920 IP phones).
Permitted
Values
String within 32 characters
Default Blank
Web UI Features->Forward&DND->Forward->No Answer Forward->On Code
Phone UI Menu->Features->Call Forward->No Answer Forward->On Code
Parameter forward.no_answer.off_code <y0000000000xx>.cfg
Description
It configures the no answer forward off code to deactivate the server-side no answer forward feature.
The IP phone will send the no answer forward off code to the server when you deactivate the no answer
forward feature on a phone basis.
Note: It works only if “features.fwd.allow” is set to 1 (Enabled) and the value of the parameter “fea-
tures.fwd_mode” is set to 0 (Phone) (except T19(P) E2/CP920 IP phones).
Permitted
Values
String within 32 characters
Default Blank
Web UI Features->Forward&DND->Forward->No Answer Forward->Off Code
Phone UI Menu->Features->Call Forward->No Answer Forward->Off Code
Call Forward in Custom Mode Configuration
The following table lists the parameters you can use to configure call forward in Custom mode.
Parameter
account.X.always_fwd.enable
[1]
<MAC>.cfg
Description
It triggers always forward feature to on or off.
Note: It works only if “features.fwd.allow” is set to 1 (Enabled) and “features.fwd_mode” is set to 1 (Cus-
tom). It is not applicable to T19(P) E2/CP920 IP phones.
Permitted
Values
0-Off
1-On, incoming calls to the account X are forwarded to the destination number (configured by the para-
meter “account.X.always_fwd.target”) immediately.
Default 0